Passive Mixer-based UWB Receiver with Low Loss, High Linearity and Noise-cancelling for Medical Applications

Thaar Abdalraheem Kareem, Hatem Trabelsi

Abstract


A double balanced passive mixer-based receiver operating in the 3-5 GHz UWB for medical applications is described in this paper. The receiver front-end circuit is composed of an inductorless low noise amplifier (LNA) followed by a fully differential voltage-driven double-balanced passive mixer. A duty cycle of 25% was chosen to eliminate overlap between LO signals, thereby improving receiver linearity. The LNA realizes a gain of 25.3 dB and a noise figure of 2.9 dB. The proposed receiver achieves an IIP3 of 3.14 dBm, an IIP2 of 17.5 dBm and an input return loss (S11) below -12.5dB. Designed in 0.18μm CMOS technology, the proposed mixer consumes 0.72pW from a 1.8V power supply. The designed receiver demonstrated a good ports isolation performance with LO_IF isolation of 60dB and RF_IF isolation of 78dB.

Full Text:

PDF

References


L. Xia, K. Shao, H. Chen, Y. Huang, Z. Hong, and P. Y. Chiang, “0.15-nJ/b 3–5-GHz IR-UWB system with spectrum tunable transmitter and merged-correlator noncoherent receiver,” IEEE Trans. Microw. Theory Tech., vol. 59, no. 4, pp. 1147–1156, 2011.

L. Liu, T. Sakurai, and M. Takamiya, “A charge-domain auto-and cross-correlation based data synchronization scheme with power-and area-efficient PLL for impulse radio UWB receiver,” IEEE J. Solid-State Circuits, vol. 46, no. 6, pp. 1349–1359, 2011.

Jihai Duan, Q. Hao2, Y. Zheng, B. Wei, W. Xu, and S. Xu, “Design of an Incoherent IR-UWB Receiver Front-End in 180-nm CMOS Technology.” 16th IEEE International Symposium on Quality Electronic Design (ISQED), pp. 186-190, 2015.

B. Shi and M. Y. W. Chia, “Design of a CMOS UWB receiver front-end with noise-cancellation and current-reuse,” in 2010 IEEE International Conference on Ultra-Wideband, vol. 1, pp. 1–4, 2010,.

H. Trabelsi, I. Barraj, and M. Masmoudi, “A 3–5 GHz FSK-UWB transmitter for wireless personal healthcare applications,” AEU-International J. Electron. Commun., vol. 69, no. 1, pp. 262–273, 2015.

B. Saif and T. Hatem, “Low-complexity passive mixer-based UWB pulse generator with leakage compensation and spectrum Tunability,” in 2020 IEEE International Conference on Design & Test of Integrated Micro & Nano-Systems (DTS), pp. 1–5, 2020.

S. Benali and H. Trabelsi, “Analysis of device mismatches effect on the performance of UWB-Ring VCO,” in 2020 17th International Multi-Conference on Systems, Signals & Devices (SSD), pp. 814–818, 2020.

R. S. Rao, Microwave engineering. PHI Learning Pvt. Ltd., 2015.

B. Razavi and R. Behzad, RF microelectronics, vol. 2. Prentice hall New York, 2012.

B. Razavi et al., “A 0.13/spl mu/m CMOS UWB transceiver,” in ISSCC. 2005 IEEE International Digest of Technical Papers. Solid-State Circuits Conference, pp. 216–594, 2005,.

C. Sandner et al., “A wimedia/mboa-compliant cmos rf transceiver for uwb,” IEEE J. Solid-State Circuits, vol. 41, no. 12, pp. 2787–2794, 2006.

Y. Zheng et al., “A CMOS carrier-less UWB transceiver for WPAN applications,” in 2006 IEEE International Solid State Circuits Conference-Digest of Technical Papers, pp. 378–387, 2006.

E. C. M. Association, “High rate ultra wideband PHY and MAC standard,” Stand. ECMA-368 2nd Ed., 2007.

M. Y. Algumaei, N. A. Shairi, Z. Zakaria, and I. M. Ibrahim, “Review of mixer and balun designs for UWB applications,” Int. J. Appl. Eng. Res., vol. 12, no. 17, pp. 6514–6522, 2017.

F. Marki and C. Marki, “Mixer basics primer,” Marki Microw., 2010.

H. Khosravi, A. Bijari, N. Kandalaft and J. Cabral, "A Low Power Concurrent Dual-Band Low Noise Amplifier For WLAN Applications," 2019 IEEE 10th Annual Information Technology, Electronics and Mobile Communication Conference (IEMCON), pp. 1118-1123, 2019.

R. Bagheri et al., “An 800-MHz–6-GHz software-defined wireless receiver in 90-nm CMOS,” IEEE J. Solid-State Circuits, vol. 41, no. 12, pp. 2860–2876, 2006.

F. Bruccoleri, E. A. M. Klumperink, and B. Nauta, “Wide-band CMOS low-noise amplifier exploiting thermal noise canceling,” IEEE J. Solid-State Circuits, vol. 39, no. 2, pp. 275–282, 2004.

S. C. Blaakmeer, E. A. M. Klumperink, D. M. W. Leenaerts, and B. Nauta, “Wideband balun-LNA with simultaneous output balancing, noise-canceling and distortion-canceling,” IEEE J. Solid-State Circuits, vol. 43, no. 6, pp. 1341–1350, 2008.

C.-F. Liao and S.-I. Liu, “A broadband noise-canceling CMOS LNA for 3.1–10.6-GHz UWB receivers,” IEEE J. Solid-State Circuits, vol. 42, no. 2, pp. 329–339, 2007.

B. Mouna, B. Saif, B. Ghazi, and T. Hatem, “Analysis and Optimization of RF Front-End for MICS Band Receiver,” in 2019 IEEE International Conference on Design & Test of Integrated Micro & Nano-Systems (DTS), pp. 1–5, 2019.

M. Bettaieb, S. Benali, G. Bouzid, and H. Trabelsi, “Analysis and optimization of RF Front-End for MICS Band Receiver.” IEEE International Conference on Design & Test of Integrated Micro & Nano-Systems Analysis, p. 5, 2019.

W. Xie, X. Li, and X. Long, “Underground Operator Monitoring Platform Based on Ultra-Wide Band WSN.,” Int. J. Online Eng., vol. 14, no. 10, 2018.

M. U. Nair, Y. Zheng, C. W. Ang, Y. Lian, X. Yuan and C. -H. Heng, "A Low SIR Impulse-UWB Transceiver Utilizing Chirp FSK in 0.18 µm CMOS," in IEEE Journal of Solid-State Circuits, vol. 45, no. 11, pp. 2388-2403, Nov. 2010, doi: 10.1109/JSSC.2010.2074232.

Z. Zou et al., “A low-power and flexible energy detection IR-UWB receiver for RFID and wireless sensor networks,” IEEE Trans. Circuits Syst. I Regul. Pap., vol. 58, no. 7, pp. 1470–1482, 2011.

T. A. Vu, H. A. Hjortland, O. Nass, and T. S. Lande, “A 3-5 GHz IR-UWB receiver front-end for wireless sensor networks,” Proceedings - IEEE International Symposium on Circuits and Systems. pp. 2380–2383, 2013, doi: 10.1109/ISCAS.2013.6572357.

G. Cusmai, M. Brandolini, P. Rossi and F. Svelto, "A 0.18-µm CMOS Selective Receiver Front-End for UWB Applications," in IEEE Journal of Solid-State Circuits, vol. 41, no. 8, pp. 1764-1771, Aug. 2006, doi: 10.1109/JSSC.2006.877256.


Refbacks

  • There are currently no refbacks.


International Journal of Electronics and Telecommunications
is a periodical of Electronics and Telecommunications Committee
of Polish Academy of Sciences

eISSN: 2300-1933